INSTRUCTIONS FOR
THE
HAFLER
DH-502 AMPLIFIER BRIDGING KIT
FOR THE DH-500
The DH-502 Amplifier Bridging Kit for the
DH-500
consists
of a PC-7A circuit board comprising a 6 transistor phase inverting
amplifler, a
mounting bracket, necessary hardwareandconnecting
wire.
Installation may take about an hour. All changes to the
amplifier wiring are performed on the right channel
-
the side
nearest
the power switch. Only the left
channel input will be utilized
after conversion so an additional pair of input wires will be
connected to that jack to enabie it
to
feed the complete amplifier.
When converted to monophonic operation, the loudspeaker
load is
to
be connected to the
two
centerred
(+)
outputs only. The
right
(+)
will act as the common and should be attached to the
speaker
(-)_
This is what is known as a floating output, for no
connection is made to either black ground terminal. It is sug-
gested that once the amplifier has
been
converted, some clear
indication be made as to the appropriate connections, and that
be
attched to the back panel.
Because of this
floating
output, neither
side of the output signal may be grounded; such as
thru
a
speaker
switching box or head phone adapter that has a common ground
between the left and right channels.
For equivalent load impedances, the speaker
fuses
provide
the
same power output protection as in stereo operation, but because
of individual
fuse variations,
only one fuse may blow at
these
levels. It is best to replace both fuses if one blows,
as
the other
may have been weakened.
These installation instructions designate connections in ac-
cordance with the DH-500 owner’s manual and pictorial diagram,
and use the same terminology (i.e.
“S”
indicates a
soldcrcd
connection),
KIT PARTS LIST
1
PC-7 Board
WP-PC7
1
M
ounting
bracket
SM-BRT202*
2
Screw,
Machine, 4-40 x
5/16”
HWH-145
2
Nut. 4-40 KEP
HWH-105
1
Wire
Red
#20
GA
3.0’
I
Wire, Green
#20
GA
3.0’
1
Warranty
Card
LIT-WAR
TO
ORIYER
CAR0
B-
LIMITED WARRANTY
The
parts
in the
DH-502
are
warranteed for a full year from the purchasedateincluding
parts
and labor. If a defective componcnr is found on a
circuit
board
or
in
the
kit, simply return
the
individual
part, or if the problem is unknown, retumthedefcctive board to
the
factory,
prepaid, together
with
the
serial
number
and a
copy
of
the
dated bill of sale, and it wil
be
repaired or replaced
at no
charge. This warranty is limited to repair or replacement of
the
DH-502 bridging
module only. Hafler is not responsible for consequential damages. This
warranty
gives you specific legal rights. You may also have other
rights
which
vary from state lo state.
This warranty is void if acid core solder or paste flux has been used.
A Division Of Rockford Corporation
613 S. Rockford Drive, Tempe, Arizona 85281
l
(602) 967-3565
(12 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals